It can be seen from the development of the magnetic drill that the magnetic drill requires precision. Our ordinary operators need to understand its basic principle, but the best way to repair this magnetic drill is to disassemble, assemble and repair it by professionals. On the one hand, the high voltage and high magnetic drill will be generated after the internal power supply of the magnetic drill, and non-professionals are afraid of life danger; on the other hand, the high precision drill hole by magnetic drill, and the non-professionals disassemble and assemble panic films.Sound its accuracy.

Note: Before inspection, maintenance and maintenance, always turn off the switch and unplug the power plug.

1. The magnetic drill should be stored in a dry, clean environment, free from corrosive gases and out of reach of children;

2. When disassembling and inspecting the magnetic drill, each part shall be kept in good condition, and all parts shall be assembled in their original position, without missing or mis-assembling.

3. The drive parts of the magnetic drill should be frequently filled with lubricating oil and kept clean.

4. The magnetic drill should regularly check for maintenance. It must check whether the power supply line, plug and switch are good, whether the consumables (carbon brush, grease) are sufficient, whether the insulation resistance is normal, and whether the transmission is damaged.

5. Whether the resistance of the magnetic base is normal or whether there is leakage.

Maintenance essentials for daily maintenance of magnetic drill and magnetic stand drill: First, for your safety of life, before inspection and maintenance, you must turn off the magnetic drill switch and unplug the power plug, so as to ensure safety.

1. The main points of daily maintenance of the magnetic drill/magnetic base drill should be checked regularly, including whether the power cord, internal wiring, plug and shunt are good, whether the insulation resistance is normal, and whether the transmission parts are damaged.

2. The main points of daily maintenance of magnetic drill/magnetic base drill are driven by gears. The transmission of gears is contact type, which needs to be lubricated with oil frequently and kept clean so as to ensure that the gears of our magnetic drill are not easy to wear out during the trial.(Note: It is recommended to add lubricant once a month if the operation is heavy)

3. When disassembling and inspecting the main points of the daily maintenance of the magnetic drill/magnetic base drill, each part, including the insulating liner and casing, should be well saved.In case of damage, new identical parts must be replaced and all parts should be assembled in their original positions without missing them.

4. Keep the key points of daily maintenance of the magnetic drill/stand drill in a dry, clean and non-corrosive environment and out of reach of children.

5. If the main points of daily maintenance of the magnetic drill/magnetic base drill are too long and the motor becomes hot, it is necessary to stop and rest to avoid burning the motor due to overheating.

6. If the daily maintenance points of the magnetic drill/magnetic base drill are not used for a long time, remember to remove the drill bit, keep the drill bit and drill handle clean, and do a good job of anti-rust measures.